Am-Tech Installation Instructions

This appliance is approved for Built-In Installation.

UL Approved

Very Important: The inside of the washer dryer, which consists of a floating unit, is fixed with screws and tabs at the back of the cabinet during transport. Before starting the machine remember to release the floating unit by removing the above screws and take down the reinforcing iron piece. Otherwise, damage to the machine or household and even personal injury may occur. It is important for the machine to be perfectly level. For this reason the machine is fitted with adjustable feet used for leveling the machine before use. In the case of flooring with carpet, remember to check that the ventilation in the support area is not plugged.

Installation Instructions

1. Remove 2 shipping rods on back of machine and remove the four shipping bolts that hold the drum in place.
   .

2. Using the wrench provided with the machine, adjust the height of the legs so the machine is level.
   .

3. When installing the water fill hoses it is very important that the cold water line is connected to the valve marked "C" on back of the machine, and the hot water line to the valve marked "H". If installed incorrectly the machine will not dry.
   .

4. The drain hose must be installed between 28" to 36" from the bottom of the machine and there must be an air break to prevent the machine from siphoning.